ENGWE Display Wiring Cable 140 cm for EP-2 Pro / Engine Pro / M20

ENGWE replacement display wiring cable (display-to-controller) for the ENGWE EP-2 Pro electric bicycle. It may also fit selected ENGWE Engine Pro, M20 and other ENGWE e-bike models using the same display connector and wiring configuration.

Cable length: approximately 140 cm.

Important: compatibility with models other than the ENGWE EP-2 Pro depends on the connector type, pin configuration and wiring layout. Please compare the connectors and cable configuration with your original part before ordering.

Compatible ENGWE E-Bike Models

• ENGWE EP-2 Pro
• Selected ENGWE Engine Pro versions with the same display wiring configuration
• Selected ENGWE M20 versions with the same display wiring configuration
• Other ENGWE e-bike models using the same display connector and wiring configuration

ENGWE Display Wiring Cable

This replacement cable provides the electrical connection between the handlebar display and the e-bike controller.

It can be used to replace an original display cable that has been damaged, worn or has developed an unreliable connection.

Possible Symptoms of a Damaged Display Cable

A damaged display cable or connector may cause symptoms such as:

• the display does not switch on;
• the display switches off intermittently;
• the display loses connection while riding;
• the display works only when the cable or connector is moved;
• visible damage to the cable insulation or connector;
• damaged, bent or contaminated connector pins.

Please note that similar symptoms can also be caused by the display, controller, battery, wiring harness or other electrical components. Replacing the cable does not guarantee that the cable itself is the cause of the electrical fault.

Compatibility With Other ENGWE Models

This cable may also fit selected ENGWE electric bicycles that use the same connector and wiring configuration as the EP-2 Pro.

ENGWE may use different electrical components, connectors or wiring harnesses between different models and production versions. For this reason, the bicycle model name alone may not always be sufficient to confirm compatibility.

How to Check Compatibility

Before ordering, compare your original display cable with the product photos and check:

• connector shape;
• number of connector pins;
• connector gender;
• connector orientation;
• cable configuration;
• cable length – approximately 140 cm;
• display-to-controller connection points.

Replacing the ENGWE Display Wiring Cable

Before disconnecting or replacing electrical components, switch off the e-bike and disconnect or remove the battery where appropriate.

Follow the original cable routing and make sure that the replacement connectors match the existing display and controller connections before installation.

Do not force electrical connectors together. If the connector shape, pin arrangement or orientation is different, the cable may not be compatible.

Not Sure If This ENGWE Display Cable Fits?

If you are unsure whether this display wiring cable is compatible with your ENGWE e-bike, please contact us before ordering.

For compatibility checking, please send us clear photos of:

• both connectors on your original cable;
• the connector pins;
• the complete original cable;
• any markings or part numbers;
• your ENGWE bike model and model year, if known.

You can also browse our e-bike parts and replacement components available from Elanus Parts.